Err

Same day shipping / Next day delivery
The UK's home of peelable, sprayable paint since 2012

Matt-Pack Spray Wrap PRO Ultra High Gloss Topcoat - Part 1

FullDip
(Code: mpswtcg1pt1)
In Stock

Fuel and scratch resistant Peelable High Gloss

You can flat and polish this (we recommend 2 wet coats if flatting and polishing).
NOT designed for DIY use. PRO Gloss
Requires a compressor setup to do properly
Ultra High Solids. MUCH better for sanding and polishing up or flow-coating.

£ 47.99
1100g

 

Fuel and scratch resistant Peelable High Gloss

You can flat and polish this (we recommend 2 wet coats if flatting and polishing).
NOT designed for DIY use. PRO Gloss
Requires a compressor setup to do properly




Matt-Pack Ultra High Gloss

fuel and scratch resistant
can be sanded and polished
Ultra High Solids. MUCH better for sanding and polishing up or flowcoating.

 

2 stage application;

mix the gloss and hardener 2:1 add 5-15% of the optimiser and spray on

one dust coat

one or two wet coats (your choice - we recommend 2 if flatting and polishing)

Contains 2x 1 litre gloss,


This product is not recommended for the non professional. It contains chemicals that are not good for you. You need the proper PPE equipment. Full protective suit and at minimum an organic, inorganic mask.


Info sheet HERE


For a compressor setup, we use here a 3m Accuspray, we use the 1.4 at @ 2bar and get the results below. . If you spray in a professional booth, again you will get better results, if not, do not expect perfection. Dust is your enemy with this product. You could get away with it, with just a normal matte / satin finishes, but high gloss will show up dirt and dust badly. Just be realistic in your expectations. Also if you do not put minimum 7 WET coats of Full Dip liquid wrap down you will struggle to peel in the future. It will not be the products fault, but your own for skimping on product to start with.

Using a compressor and gun setup - Our recommendation is minimum 3 hp, minimum 14CFM and at least 200 litres air storage. Belt driven are better and quieter than v twins, and last longer too. Screw compressors are by far the best (and most expensive). An air drier is pretty essential too (better spray and removes a lot of orange peel). As for guns we use a 3m Accuspray for the gloss

We personally would label this as semi permanent over Plasti Dip®. It WILL DEFINITELY peel, but not as well as standard Plasti Dip® with out it. If you do not put enough PlastiDip® down first it will be VERY difficult to peel. It is tricky to apply and if your spraying is not good, will be very orange peel. This is pretty difficult to spray properly to get flat and have no runs. Not for a first dip at all. We would say at least 5 + dips before you attempt this. We recommend using over the Matt-Pack Spray Wrap or the FullDip, it works 100% better and peels 100% better. If using PD, bang an EXTRA gallon or two minimum of dip on (dependent on original amount).








 
Get orangepeel? Here's how to fix it :)


Fully Auth Distributor

Secure Payments

Shipping Information